You no doubt have wondered about the differences between different types of injection molds. Read on for a breakdown of the various injection mold classifications. Of course, if you have any further questions, don’t hesitate to reach out to us.
This mold is built for extremely high production (cycles of one million or more). Because of this, it’s the highest-priced mold and is made with only the highest quality materials. It requires a detailed mold design and its base needs to be a minimum hardness of 28 R/C. The molding surfaces (cavities and cores) must be hardened to a minimum of 48 R/C range. Any other details (ie: sub-inserts, slides, heel blocks, etc) should also be of hardened tool steels.
Over the life of the mold, any build-up or corrosion in the vented cooling channels will decrease the cooling efficiency, thus degrading the part quality and increasing the cycle time. Because of this, it’s recommended that plates or inserts containing cooling channels be of a corrosive resistant material or be treated to prevent corrosion.
Other factors to consider:
Class 102 is for medium to high production with cycles not exceeding one million. It’s a high-quality, fairly high-priced mold that’s good for abrasive materials and/or parts requiring close tolerances. It requires a detailed mold design. The mold base needs a minimum hardness of 28 R/C and molding surfaces should be hardened to a 48 R/C range. All other functional details should be made and heat treated. Temperature control provisions should be directly in the cavities, cores, and slide cores wherever possible. Note that parting line locks are recommended for all molds.
While the following items may or may not be required depending on the quantities needed, they’re recommended for quoting purposes:
Good for cycles under half a million, this is a very popular mold for low to medium productions in the most common price range. A detailed mold design is recommended and the mold base must be a minimum hardness of 8 R/C with cavity and cores 28 R/C or higher. All other extras are optional.
Class 104 is a low-production mold (under 100,000). It’s used only for limited production, preferably with non-abrasive materials. It’s in the low to moderate price range. It’s recommended to have a mold design and its base can be of mild steel or aluminum. Any cavities can be of aluminum, mild steel or any other agreed upon metal.
This mold is for prototypes only with cycles not exceeding 500. It’s constructed in the least expensive manner possible from cast metal, epoxy, or any other material offering sufficient strength to produce minimum prototype pieces.
Still not sure what mold class is right for your project? Contact us and we’ll find the right mold for you.